Maximum Weight Loads for 36 Long 80/20 T-Slot Aluminum Bars. Is your's as straight forward to make as it appears? As a new, inexperienced table saw user, I'd really like to keep the riving knife and blade guard in place whenever possible, though that would be very challenging if not impossible since you'd have to cut through the end of the insert completely. T SLOT extrusion tops, lower shelves, locking casters.Table Saw Fence. You unbolt your existing round rails, and bolt on the angle iron, then you bolt the square tube. For instance, a new Biesermeyer fence comes with the actual fence, two pieces of angle iron (pre drilled), and a square tube. One more thing, I'd like to make a zero-clearance insert. Any fence that you buy, will come as a complete unit, including guide rails. I was searching for ideas and came across this post, and this seems like it might be a good approach to giving a flatter, longer, and sturdier fence.Īlso, have you noticed the miter slots aren't all that uniform? I'm making a crosscut sled with an Incra slider, and there are several places where it binds, and if I loosen the adjustment screws then I feel like there is too much play, though I'm not experienced enough to know how much play is acceptable. INCRA CleanSweep Downdraft Dust Collection Cabinet > more. When everything is tightened, the fence flexes and moves. Available with 32' or 52' capacity TS Systems and are available either with or without router tables. I setup the fence to be parallel with the miter slot using Woodpeckers table saw gage pin system. 002' outward of the miter slot at the exit side. Going on 4+ months how are you liking the fence? I just got a DW745 table saw, and noticed the stock fence has fairly thin aluminum walls, and with a dial indicator showed a bit of waviness, about 0.02' max, though front and back are closer than that, so it dips in the middle. The saw is pretty good except for the fence.

8020 t slot table saw fence